LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Power Brake Booster Outlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place drain pans under the vehicle as needed.
  2. Remove as much power steering fluid from the power steering fluid reservoir as possible.
    3. Fig 1: Power Brake Booster Outlet Hose
    GM650861Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Power Steering Hose Disconnected Caution .

  3. Disconnect the power brake booster outlet hose (1) from the power brake booster (2).
  4. Disconnect the power brake booster outlet hose (1) from the power steering fluid reservoir (3).
  5. Remove the power brake booster outlet hose (1) from the vehicle.
scientia non olet · About LEMON Manuals