Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the power brake booster inlet hose (1) to the vehicle.
- Connect the power brake booster inlet hose (1) to the power brake booster (2).
Tighten
Tighten the fitting to 32 N.m (24 lb ft).
- Connect the power brake booster inlet hose (1) to the power steering pump (3).
Tighten
Tighten the fitting to 32 N.m (24 lb ft).
- Clean any excess fluid from the vehicle and remove the drain pans.
- Install the engine shield. Refer to Engine Shield Replacement .
- Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
CAUTION:
The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation easier. Failure to follow these procedures could result in component damage.
CAUTION:
Refer to Fastener Caution .
NOTE:
Start both power brake booster inlet hose fittings by hand before finalizing torques.