Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Engine running, then center the steering wheel, observe the scan tool Steering Wheel Position parameter, the reading should be 0 +/- 10 degrees.
- If not within the specified range, perform the steering position torque sensor calibration, and verify DTC C0460 is not set as current.