Shock Absorber Replacement (2500 Series)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Shock Absorber (2500 Series)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Shock Absorber Retaining Nut CAUTION: Refer to Fastener Caution . TIP: Support the lower control arm with a safety stand. Tighten 24 N.m (17 lb ft)
2	Insulator (Qty: 2) Install the lower insulator, which is smaller than the upper insulator and plastic pilot ring. Install the upper insulator, which is the larger of the 2 insulators.
3	Retaining Nut Tighten 80 N.m (59 lb ft)
4	Mounting Bolt
5	Shock Absorber TIP: If replacing the shock absorber, refer Shock Absorber Disposal for the proper disposal procedure.