LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Rear Drive Axle) >> Repair Instructions >> Vent Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Notice the routing of the vent hose to ensure the correct positioning for reassembly.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Rear Axle Vent Hose
    GM788622Courtesy of GENERAL MOTORS CORP.
  2. Remove the vent hose from the rear axle vent hose connector.
    3. Fig 2: Vent Hose Removed Clip Attached To Frame
    GM788624Courtesy of GENERAL MOTORS CORP.
  3. Remove the vent hose from the retaining clip on the frame.
scientia non olet · About LEMON Manuals