LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) , Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) .
  4. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
    5. Fig 1: Wheel Speed Sensor Ring And Axle Housing
    GM889095Courtesy of GENERAL MOTORS CORP.
    NOTE:

    If the vehicle is equipped with VSES, proceed to step 5.

  5. Using the J 44685  remover (1) and the J 2619-01  hammer (2), remove the rear axle shaft seal.
  6. Using the J 45857  remover (1) and the J 2619-01  hammer (2), remove the rear axle shaft seal, bearing and the wheel speed sensor reluctor ring, if equipped.
scientia non olet · About LEMON Manuals