LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Axle Cover And Bolts
    GM1689173Courtesy of GENERAL MOTORS CORP.
  1. If the gasket is to be re-used, clean the sealing surfaces of the rear axle housing and the rear axle cover with a suitable cleaner.
  2. Install the rear axle housing cover gasket (3) and the cover (2) to the rear axle housing.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the rear axle housing cover bolts (1) and tighten to 30 N.m (20 lb ft).
  4. Install the drain plug for the 9.5 inch axle. Refer to Differential Oil Replacement (8.6 Inch Axle) , Differential Oil Replacement (10.5 Inch Axle) , Differential Oil Replacement (9.5LD Inch Axle) .
  5. Fill the rear axle with the proper axle lubricant. Refer to Rear Axle Lubricant Level Inspection (8.6, 9.5 LD Axle) , Rear Axle Lubricant Level Inspection (10.5 Inch Axle) .
  6. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals