LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Rear Drive Axle) >> Repair Instructions >> Locking Differential Cam Unit Disassemble (9.5 Inch Axle) >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure and record the overall length of the locking differential side gear assembly from the front of the locking differential side locking differential side gear to thrust washer.
  2. Remove the guide clips.
    3. Fig 1: Thrust Sleeve And Special Tools
    GM886078Courtesy of GENERAL MOTORS CORP.
  3. Using the J 22912-01  puller (2), J 45232  replacer (1) and a hydraulic press, remove the locking differential side gear thrust sleeve.
    4. Fig 2: Disassembled View Of Locking Differential Side Gear Components
    GM2158654Courtesy of GENERAL MOTORS CORP.
  4. Remove the locking differential clutch disc thrust washer (7).
  5. Remove the locking differential side gear thrust sleeve (6).
  6. Remove the locking differential clutch disc set (1).
    7. NOTE:

    The locking differential clutch disc guide is NOT serviced separately. It is serviced with the locking differential clutch disc assembly.

  7. Remove the locking differential clutch disc guide.
  8. Disassemble the locking differential clutch disc assembly (1).
scientia non olet · About LEMON Manuals