LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Rear Drive Axle) >> Repair Instructions >> Differential Overhaul (8.6, 9.5LD Inch Axles) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential ring gear. Refer to Drive Pinion and Ring Gear Replacement (10.5 Inch Axle) , Drive Pinion and Ring Gear Replacement (8.6, 9.5LD Inch Axles) 
  2. Remove the differential side bearings. Refer to Differential Bearing Replacement .
    3. Fig 1: Side Gears, Pinion Gears & Attached Components
    GM2152359Courtesy of GENERAL MOTORS CORP.
  3. Remove and discard the differential pinion gear shaft lock bolt (2). Replace with NEW only.
  4. Remove the differential pinion gear shaft (1).
    5. NOTE:

    Mark the top and bottom differential pinion gears and thrust washers, if reusing.

  5. Roll the differential pinion gears (7) and the thrust washers (6) out of the differential case 2).
    6. NOTE:

    Mark the left and right side differential side gears and the thrust washers, if reusing.

  6. Remove the differential side gears (5) and the thrust washers (4).
scientia non olet · About LEMON Manuals