LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Rear Drive Axle) >> Repair Instructions >> Differential Oil Replacement (8.6 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear axle cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) , Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) .
  2. Fill the rear axle with axle lubricant. Use the proper fluid. Refer to Approximate Fluid Capacities , and Adhesives, Fluids, Lubricants, and Sealers .
    3. Fig 1: Rear Axle Fill Plug
    GM392774Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  3. Install the rear axle fill plug and tighten to 33 N.m (24 lb ft).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals