Locking Rear Axle Locks in Turns
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Locking Rear Axle Locks in Turns
| Checks |
Action |
| The governor assembly is tight in the case |
Free up the governor assembly. Refer to Locking Differential Disassemble (8.6/9.5LD Inch Axles) , Locking Differential Disassemble (10.5 Inch Axle) , and Locking Differential Assemble (10.5 Inch Axle) , Locking Differential Assemble (8.6, 9.5LD Axles) . |
| Broken or weak governor flyweight spring |
Replace the governor assembly and the latching bracket. Refer to Locking Differential Disassemble (8.6/9.5LD Inch Axles) , Locking Differential Disassemble (10.5 Inch Axle) , and Locking Differential Assemble (10.5 Inch Axle) , Locking Differential Assemble (8.6, 9.5LD Axles) . |
| The flyweight in the governor assembly is stuck open |
Replace the governor assembly and the latching bracket. Refer to Locking Differential Disassemble (8.6/9.5LD Inch Axles) , Locking Differential Disassemble (10.5 Inch Axle) , and Locking Differential Assemble (10.5 Inch Axle) , Locking Differential Assemble (8.6, 9.5LD Axles) . |
| The cam plate or the governor drive teeth are broken |
Replace the cam plate, the governor assembly, and the latching bracket. Refer to the following:
|