Rear Output Shaft Bushing Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Output Shaft Bushing

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Ensure the bushing is installed squarely into the bushing bore.
1	Transfer Case Rear Output Shaft Bushing TIP: Press the bushing until the tool bottoms on the rear case half. Special Tools GE-8092 Driver Handle Driver Handle DT-48022 Output Bushing Installer DT-48209 Bushing Remover For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure
Ensure the bushing is installed squarely into the bushing bore.

Transfer Case Rear Output Shaft Bushing
TIP: Press the bushing until the tool bottoms on the rear case half.

Special Tools

GE-8092 Driver Handle Driver Handle
DT-48022 Output Bushing Installer
DT-48209 Bushing Remover

For equivalent regional tools, refer to Special Tools .