LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 338 (Transfer Case - Mp 3023/3024-NQH) >> Diagnostic Information and Procedures >> DTC C0896 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the TREC fuse, and the Miscellaneous IGN fuse, underhood fuse block, are NOT open.
    • If the TREC fuse is open, test the battery positive voltage circuit, TCCM harness X3 pin C, for a short to ground.
    • If the Miscellaneous IGN fuse is open, test the Ignition 1 voltage circuit, TCCM harness X2 pin 6, for a short to ground.
  2. Ignition ON, engine OFF.
  3. Using the Freeze Frame feature of the scan tool, review the Battery Voltage parameter when the DTC sets. The voltage should be above 12.0 V.
    • If the voltage is above 18.5 V, this is likely a vehicle issue such as an alternator problem, or the vehicle has been hooked up improperly during a jump start. Refer to Symptoms - Engine Electrical .
  4. Using the Transfer Case Data Display feature of the scan tool, monitor the Battery Voltage parameter. The voltage should be above 12.0 V.
  5. While monitoring the Battery Voltage parameter, start the engine. Rev the engine to greater than 3000 RPM. The voltage should remain stable and below 18.5 V.
    • If the voltage is unstable or is greater than 18.5 V, ensure that the charging system is working properly. Refer to Charging System Test .
scientia non olet · About LEMON Manuals