Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the retaining springs to the caliper bracket.
- Install the brake pads.
- Install the caliper to the caliper bracket.
- Install the brake caliper guide pin bolts to the caliper bracket. DO NOT tighten.
- Install the caliper and caliper bracket (1) as an assembly.
- Perform the following procedure before installing the caliper bracket bolts.
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
- Install the brake caliper bracket mounting bolts (2) and tighten to 200 N.m (148 lb ft).
- Tighten the brake caliper guide pin bolts to 108 N.m (80 lb ft).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained to properly seat the brake caliper pistons and brake pads.
- Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling .
CAUTION:
Refer to Fastener Caution .