LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Disc Brake System) >> Repair Instructions >> Front Disc Brake Pads Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install NEW brake pad retaining springs to the caliper bracket.
  2. Install the disc brake pads to the brake caliper bracket, positioning the brake pad wear sensor (if equipped) as noted during removal.
    3. Fig 1: Brake Caliper Mounting Pin Bolts
    GM789166Courtesy of GENERAL MOTORS CORP.
  3. Install the brake caliper to the caliper bracket.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the brake caliper guide pin bolts and tighten to 108 N.m (80 lb ft).
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
  7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  8. Slowly release the brake pedal.
  9. Wait 15 seconds, then repeat steps 7-8 until a firm brake pedal is obtained, to properly seat the brake caliper pistons and brake pads.
  10. Fill the brake master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling .
  11. Burnish the brake pads and discs. Refer to Brake Pad and Rotor Burnishing .
scientia non olet · About LEMON Manuals