Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Caliper Bracket

Courtesy of GENERAL MOTORS CORP.

Install the caliper to the caliper bracket.

Fig 2: Brake Caliper Bolts

Courtesy of GENERAL MOTORS CORP.

Install the brake caliper bolts.

Fig 3: Using Open End Wrench On Brake Caliper Guide Pin Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION:

Refer to Fastener Caution .

NOTE:

DO NOT use any air tools to remove or install the brake caliper bolts. Use hand tools ONLY.
Install an open end wrench to hold the caliper guide pin in line with the brake caliper while removing or installing the brake caliper bolt. DO NOT allow the open end wrench to come in contact with the brake caliper. Allowing the open end wrench to come in contact with the brake caliper will cause a pulsation when the brakes are applied.

Using an open end wrench to hold the guide pins while tightening the brake caliper bolts to 100 N.m (74 lb ft).
Remove the cap or plug from the brake hose fitting end.

Fig 4: Brake Hose Fitting

Courtesy of GENERAL MOTORS CORP.

Install the brake hose to caliper bolt and tighten to 40 N.m (30 lb ft).
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) , Hydraulic Brake System Bleeding (Manual) .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling .