Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake caliper bracket (1) to the steering knuckle.
- Perform the following procedure before installing the brake caliper bracket bolts.
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
- Install the brake caliper bracket mounting bolts (2) and tighten to 300 N.m (221 lb ft).
- Install NEW brake pad retaining springs to the brake caliper bracket.
- Install the brake pads. Refer to Front Disc Brake Pads Replacement (2500 Series) , Front Disc Brake Pads Replacement (1500 Series) .
- Slowly apply pressure to the brake pedal until a firm pedal as been achieved.
- Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
CAUTION:
Refer to Fastener Caution .