LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Bracket Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Caliper Bracket
    GM1479408Courtesy of GENERAL MOTORS CORP.
  1. Install the brake caliper bracket.
  2. Perform the following procedure before installing the brake caliper bracket bolts.
    1. Remove all traces of the original adhesive patch.
    2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    3. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
    3. Fig 2: Caliper Bracket Bolts
    GM1479406Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  3. Install the brake caliper bracket mounting bolts and tighten to 200 N.m (148 lb ft).
  4. Install the brake pad springs.
    5. NOTE:

    Install the brake pads in the same location noted during removal.

  5. Install the brake pads.
  6. Install the brake caliper to the bracket. Refer to Front Brake Caliper Replacement (1500 Series) , Front Brake Caliper Replacement (2500 Series) .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling .
scientia non olet · About LEMON Manuals