Rear Disc Brake Mounting and Hardware Inspection
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the disc brake caliper from the caliper mounting bracket.
- Remove the disc brake pads from the caliper mounting bracket.
- Inspect the disc brake pad mounting hardware for the following:
- Missing mounting hardware
- Excessive corrosion
- Bent mounting tabs
- Looseness at the caliper mounting bracket
- Looseness at the disc brake pads
- If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.
- Ensure the disc brake pads are held firmly in place on the caliper mounting bracket, yet slide easily on the mounting hardware without binding.
- Install the disc brake pads to the caliper mounting bracket.
- Install the disc brake caliper to the mounting bracket.
WARNING:
Refer to Brake Dust Warning .