Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: BPMV Return Hose Quick Connect

Courtesy of GENERAL MOTORS CORP.

Install the supply and return hoses to the vehicle and the retainers.
Connect the BPMV return hose quick connect (1).
Ensure the return hose quick connect is fully engaged by attempting to pull the return hose from the outlet fitting.

Fig 2: BPMV Supply Hose Quick Connect

Courtesy of GENERAL MOTORS CORP.

Connect the BPMV supply hose quick connect (1).
Ensure the supply hose quick connect is fully engaged by attempting to pull the supply hose from the inlet fitting.

Fig 3: ABS Module Splash Shield

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield (1).

CAUTION:

Refer to Fastener Caution .

Fig 4: ABS Module Splash Shield Bolts

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield bolts (1) and tighten to 20 N.m (15 lb ft).

Fig 5: ABS Module Splash Shield Retainers

Courtesy of GENERAL MOTORS CORP.

Install the ABS module splash shield retainers (1).
Lower the vehicle.

Fig 6: Reservoir Return Hose Quick Connect

Courtesy of GENERAL MOTORS CORP.

Connect the brake master cylinder reservoir return hose quick connect (1).
Connect the brake master cylinder reservoir supply hose quick connect (2).
Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .