Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the BMC primary piston position sensor (2).
- Install the 2 primary piston position sensor screws (1) and tighten to 10 N.m (89 lb in).
- Connect the primary piston position sensor electrical connector.
- Inspect the battery state of charge. Refer to Battery Inspection/Test .
- If necessary, connect a battery charger to the 12V battery. Refer to Battery Charging .
- Install a scan tool to the vehicle.
- Turn the ignition ON with the engine OFF.
- Using the scan tool, perform the following steps:
- Select Diagnostics
- Select the appropriate vehicle information
- Select Chassis
- Select Electronic Brake Control Module (EBCM)
- Select Module Setup
- Select BMC Primary Piston Position Relearn and follow the instructions on the scan tool
CAUTION:
Refer to Fastener Caution .
NOTE:
The ignition switch must remain in the ON position with the engine OFF during this procedure.