LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 333 (Hydraulic Brake System) >> Diagnostic Information and Procedures >> Brake Warning Indicator Malfunction (Without UJ1) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the park brake is released and the brake fluid is at or above the proper level.
  2. Command the IPC display test with a scan tool, the warning indicator should turn ON.
    • If the red brake warning indicator does not illuminate, replace the IPC.
  3. Ignition ON, observe the scan tool BCM Park Brake Switch parameter while applying and releasing the park brake. The parameter should cycle between Applied and Release.
    • If the parameter does not cycle between the specified values, refer to Park Brake Switch Malfunction below.
  4. Observe the scan tool IPC Brake Fluid parameter. The reading should be OK below.
    • If not the specified value, refer to Brake Fluid Level Switch Malfunction below.
scientia non olet · About LEMON Manuals