LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 332 (Antilock Brake System - Hybrid (Hp2)) >> Diagnostic Information and Procedures >> DTC C0186 or C0196 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify that DTC U0125 is not set.
    • If the DTC is not set 
  3. Verify the yaw and lateral acceleration sensor is installed correctly.
    • If loose or incorrect installation 

      Correct the installation of the component.

    • If installed correctly 
  4. Perform the Acceleration Sensor Reset procedure with a scan tool.
  5. Verify the DTC does not set while operating the vehicle under the Conditions for Running the DTC.
    • If the DTC sets 

      Refer to Circuit/System Testing below.

    • If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals