LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Engine Electrical - Hybrid) >> Repair Instructions >> Engine Ground Strap Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ground Strap Nut
    GM663474Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Install the ground strap to the stud.
  2. Install the ground strap nut to the stud at the front of dash and tighten to 9 N.m (80 lb in).
    3. Fig 2: Engine Wiring Harness Ground Bolt At Engine Block
    GM663475Courtesy of GENERAL MOTORS CORP.
  3. Position the ground strap and engine wiring harness ground.
  4. Install the engine wiring harness ground bolt and tighten to 16 N.m (12 lb ft).
scientia non olet · About LEMON Manuals