LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Engine Electrical - Hybrid) >> Repair Instructions >> Battery Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Assembly, Hold Down And Bolt
    GM1968645Courtesy of GENERAL MOTORS CORP.
  1. Install the battery assembly (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the battery hold down (3) and bolt (1) and tighten to 25 N.m (18 lb ft).
    3. Fig 2: Locating Battery Components
    GM1968006Courtesy of GENERAL MOTORS CORP.
  3. Install the positive battery cable terminal (3) to the battery.
  4. Rotate the lever lock (1) clockwise until an audible click is heard in order to connect the positive battery cable.
  5. Position the positive battery cable insulating cover (2) over the positive terminal.
  6. Install the radiator support diagonal brace. Refer to Radiator Support Diagonal Brace Replacement .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals