LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Engine Electrical - Hybrid) >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Negative Battery Cable Assembly
    GM1968354Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable assembly (1) to the vehicle and route the cable under the positive battery cable.
    2. Fig 2: Negative Battery Cable Lead, Ground Lead And Bolt
    GM1968351Courtesy of GENERAL MOTORS CORP.
  2. Raise and suitably support the vehicle.
  3. Position the negative battery cable lead (3) behind the engine wiring harness ground lead (2).
  4. Place the engine wiring harness ground lead (2) and the negative battery cable lead (3) to the frame.
  5. Insert the anti-rotation tab on the engine harness ground lead into the hole in the frame.
    6. CAUTION:

    Refer to Fastener Caution .

  6. Install the engine wiring harness ground lead to the frame bolt (1) and tighten to 9 N.m (80 lb in).
  7. Lower the vehicle.
    8. Fig 3: Negative Battery Cable, Ground Terminal Bolt And Ground
    GM1968348Courtesy of GENERAL MOTORS CORP.
  8. Position the engine wiring harness ground lead (2) behind the negative battery cable lead (3).
  9. Place the negative battery cable lead (3) and the engine wiring harness ground lead (2) against the engine block boss.
  10. Install the negative battery cable ground terminal to the engine block boss bolt (1) and tighten to 50 N.m (37 lb ft).
    11. Fig 4: Negative Battery Cable Clip
    GM1968346Courtesy of GENERAL MOTORS CORP.
  11. Install the negative battery cable clip (1) to the auxiliary BEC.
    12. Fig 5: Battery Current Sensor And Engine Wiring Harness Electrical Connectors
    GM1968344Courtesy of GENERAL MOTORS CORP.
  12. Connect the engine wiring harness electrical connector (1) to the battery current sensor (2).
  13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals