LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Engine Electrical - Hybrid) >> Repair Instructions >> Battery Current Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Negative Battery Cable Clip And Current Sensor
    GM1968028Courtesy of GENERAL MOTORS CORP.
  1. Remove the negative battery cable. Refer to Battery Negative Cable Replacement .
  2. Mark the location of the negative battery cable clip (1) and remove the clip from the cable.
  3. Mark the location of the battery current sensor (2) on the battery cable with tape for reference during installation.
  4. Remove the tape securing the battery current sensor to the negative battery cable.
  5. Squeeze the negative battery cable branches together.
    6. NOTE:

    Note the orientation of the battery current sensor prior to removal.

  6. Slide the battery current sensor (2) off of the negative battery cable.
scientia non olet · About LEMON Manuals