LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Seat Heating And Cooling) >> Repair Instructions >> Heated Seat Switch Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Heated Seat Switch
    GM833444Courtesy of GENERAL MOTORS CORP.
  1. Install the front seat heater switch to the front trim panel by pressing the switch into place until the switch is completely seated.
  2. Connect the electrical connector to the front seat heater switch.
  3. Install the front trim panel. Refer to Front Side Door Trim Panel Replacement .