LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 329 (Power Seat System) >> Diagnostic Information and Procedures >> DTC B3920 or B3921 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

B3920 01 or B3920 02

  1. Ignition OFF, disconnect the X1 harness connector at the MSM.
  2. Ignition ON, verify that a test lamp does not illuminate between the control circuits listed below and ground:
    • Front vertical motor terminal 12
    • Front vertical motor terminal 13
    • Rear vertical motor terminal 15
    • Rear vertical motor terminal 16
    • Seat horizontal motor terminal 9
    • Seat horizontal motor terminal 10
    • If the test lamp illuminates, test the control circuit for a short to voltage.
  3. Test for infinite resistance between the control circuits listed below and ground:
    • Front vertical motor terminal 12
    • Front vertical motor terminal 13
    • Rear vertical motor terminal 15
    • Rear vertical motor terminal 16
    • Seat horizontal motor terminal 9
    • Seat horizontal motor terminal 10
    • If not the specified value, test the control circuit for a short to ground.
  4. Ignition OFF, disconnect the X4 harness connector at the MSM.
  5. Ignition ON, verify that a test lamp does not illuminate between the control circuits listed below and ground:
    • Lumbar horizontal motor terminal 12
    • Lumbar horizontal motor terminal 13
    • Seat recline motor terminal 15
    • Seat recline motor terminal 16
    • Adjustable pedal actuator terminal 9
    • Adjustable pedal actuator terminal 10
    • If the test lamp illuminates, test the control circuit for a short to voltage.
  6. Test for infinite resistance between the control circuits listed below and ground:
    • Lumbar horizontal motor terminal 12
    • Lumbar horizontal motor terminal 13
    • Seat recline motor terminal 15
    • Seat recline motor terminal 16
    • Adjustable pedal actuator terminal 9
    • Adjustable pedal actuator terminal 10
    • If not the specified value, test the control circuit for a short to ground.
  7. If all circuits test normal, replace the MSM.

B3921 01 or B3921 02

  1. Ignition OFF, disconnect the X4 harness connector at the MSM.
  2. Ignition ON, verify that a test lamp does not illuminate between the control circuits listed below and ground:
    • Lumbar vertical motor terminal 1
    • Lumbar vertical motor terminal 2
    • Steering wheel tilt actuator terminal 7
    • Steering wheel tilt actuator terminal 8
    • If the test lamp illuminates, test the control circuit for a short to voltage.
  3. Test for infinite resistance between the control circuits listed below and ground:
    • Lumbar vertical motor terminal 1
    • Lumbar vertical motor terminal 2
    • Steering wheel tilt actuator terminal 7
    • Steering wheel tilt actuator terminal 8
    • If not the specified value, test the control circuit for a short to ground.
  4. If all circuits test normal, replace the MSM.
scientia non olet · About LEMON Manuals