Passenger Seat Cushion Ventilation Heating and Cooling Module Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Passenger Heated Seat Module And Nuts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front passenger seat. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) . Remove the passenger seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement (without HP2) , Seat Cushion Trim Cover and Pad Replacement (with HP2) .
1	Passenger Heated Seat Module Nut (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Passenger Heated Seat Module TIP: Disconnect the electrical connector.

Callout

Component Name

Preliminary Procedure

Remove the front passenger seat. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) .
Remove the passenger seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement (without HP2) , Seat Cushion Trim Cover and Pad Replacement (with HP2) .

Passenger Heated Seat Module Nut (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Tighten
9 N.m (80 lb in)

Passenger Heated Seat Module
TIP: Disconnect the electrical connector.