LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 324 (Horn System) >> Diagnostic Information and Procedures >> Horns Malfunction (with VD1) >> Component Testing >> Notes

Component Testing: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Horn

  1. Ignition OFF, disconnect the harness connector at the appropriate horn.
  2. Install a 15 A fused jumper wire between the control terminal B and 12 V. Install a jumper wire between the ground terminal A and ground. Verify the horn emits a clear and even tone.
    • If the sound emitted is not clear and even, test or replace the horn.
scientia non olet · About LEMON Manuals