LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - Repair Instructions) >> Repair Instructions >> Knock Sensor 1 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Harness Components
    GM1699536Courtesy of GENERAL MOTORS CORP.
  1. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine wiring harness electrical connector (4) from knock sensor.
    3. Fig 2: Left Side Knock Sensor
    GM1402136Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor bolt (739) and knock sensor (718).
scientia non olet · About LEMON Manuals