Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Fastener Caution .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Unbolt the front propeller shaft from the front differential, if equipped with four wheel drive (4WD). Refer to Front Propeller Shaft Replacement .
- For vehicles equipped with a 4L60-E/4L70-E automatic transmission perform the following steps, for vehicles equipped with a 6L80-E automatic transmission proceed to step 7.
- Remove the connector position assurance (CPA) retainer.
- Disconnect the engine wiring harness electrical connector (2) from the HO2S.
- Remove the HO2S electrical connector clip (1) from the fuel line clip.
- Remove the CPA retainer (2).
- Remove the engine wiring harness electrical connector clip (1) from the fuel line clip.
- Disconnect the engine wiring harness electrical connector (3) from the HO2S.
- Remove the HO2S (1 or 2).
CAUTION:
Refer to Excessive Force and Oxygen Sensor Caution .