LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - Repair Instructions) >> Repair Instructions >> Fuel Level Sensor Replacement (2500 - 98.4L (26 gal) Tank - Front) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Level Sensor Retaining Clip
    GM1705920Courtesy of GENERAL MOTORS CORP.
  1. Slide the fuel level sensor up onto the bucket until the sensor engages the retaining tab (1).
    2. Fig 2: Fuel Level Sensor Electrical Connector (2500 - 98.4L (26 gal) Tank - Front)
    GM1705918Courtesy of GENERAL MOTORS CORP.
  2. Connect the fuel level sensor electrical connector (1) under the module cover.
  3. Install the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement (2500 LWB - 98.4L (26 gal) Tank Front) , Fuel Tank Fuel Pump Module Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) , Fuel Tank Fuel Pump Module Replacement (1500 Series) , Fuel Tank Fuel Pump Module Replacement (2500 LWB - 43.5L (11.5 gal) Tank Rear) , Fuel Tank Fuel Pump Module Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) .
scientia non olet · About LEMON Manuals