LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - Repair Instructions) >> Repair Instructions >> Fuel Level Sensor Replacement (1500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Level Sensor Tangs And Retainer
    GM1704575Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement (2500 LWB - 98.4L (26 gal) Tank Front) , Fuel Tank Fuel Pump Module Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) , Fuel Tank Fuel Pump Module Replacement (1500 Series) , Fuel Tank Fuel Pump Module Replacement (2500 LWB - 43.5L (11.5 gal) Tank Rear) , Fuel Tank Fuel Pump Module Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) .
  2. Using a small pick like tool, push in the retainer (1) in order to disengage the electrical connector.
  3. Remove the fuel level sensor electrical connector from the module cover.
  4. Push the level sensor locking tangs (2) in towards the inside of the module bucket.
    5. Fig 2: Fuel Level Sensor At Sending Unit Bucket (4.8L And 5.3L)
    GM1341846Courtesy of GENERAL MOTORS CORP.
  5. Slide the fuel level sensor up.
    6. Fig 3: Fuel Level Sensor
    GM1704577Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel level sensor from the module.
scientia non olet · About LEMON Manuals