LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Line And Canister Purge Solenoid
    GM1706143Courtesy of GENERAL MOTORS CORP.
  1. Connect the EVAP line quick connect fitting at the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
  2. Connect the EVAP line quick connect fitting at the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals