LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister to Tank (1500 SWB - 98.4L (26 gal) Tank) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Tank EVAP Lines
    GM1704507Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP lines to the fuel tank.
    2. Fig 2: Fuel Tank Clips
    GM1704505Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP line quick connect fittings at the fuel tank module and vent valve. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the EVAP lines to the fuel tank clips (1, 3, 4, and 5) and close the clips.
  4. Install the EVAP lines to the fuel tank clips (2, and 6).
    5. Fig 3: Fuel Tank Shield And Retainers
    GM1704741Courtesy of GENERAL MOTORS CORP.
  5. Install the fuel tank shields (1, and 4) and retainers (2, and 3).
  6. Install the fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) , Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank) , Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) , Fuel Tank Replacement (2500 LWB - 4.35L (11.5 gal) Tank Rear) , Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank) , Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank Front) .
scientia non olet · About LEMON Manuals