LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister Vent Solenoid Retainer
    GM1706538Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid.
  2. Slide the EVAP canister vent solenoid onto the bracket until the retainer (1) engages the clip.
  3. Connect the EVAP canister vent solenoid line quick connect fitting to the vent solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 2: EVAP Canister Vent Solenoid Electrical Connector (2500 Series)
    GM1224403Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis wiring harness electrical connector (1) to the EVAP canister vent solenoid.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals