LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - Repair Instructions) >> Repair Instructions >> Air Cleaner Resonator Outlet Duct Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: PCV Tube
    GM1696754Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Remove the positive crankcase ventilation (PCV) line (1) from the air cleaner outlet duct.
    3. Fig 2: Air Cleaner Outlet Ducts
    GM1696567Courtesy of GENERAL MOTORS CORP.
  3. Remove the radiator inlet hose clamp retainer from the outlet duct.
  4. Loosen the air cleaner outlet duct clamp (1) at the mass air flow (MAF)/intake air temperature (IAT) sensor.
  5. Loosen the air cleaner outlet duct clamp (2) at the throttle body.
  6. Lift up the air cleaner outlet duct at the resonator tab in order to separate the resonator from the stud on the intake manifold.
  7. Remove the air cleaner outlet duct from the throttle body and MAF/IAT sensor.
scientia non olet · About LEMON Manuals