LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 321 (Frame And Underbody) >> Repair Instructions >> Drivetrain and Front Suspension Frame Insulator Replacement (Short Wheel Base) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Frame Cushions And Mount Bolts (Regular Cab)
    GM720422Courtesy of GENERAL MOTORS CORP.
  1. Install the cushions (1) as necessary and raise the chassis accordingly.
  2. Perform the following procedure before installing the bolts.
    1. Remove all traces of the original adhesive patch.
    2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    3. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the body mount bolts.
    • Tighten the front mount to 70 N.m (52 lb ft).
    • Tighten all the other mounts to 165 N.m (122 lb ft).
  4. Install the park brake equalizer intermediate cable. Perform the following steps:
    1. Pull rearward on the park brake cable to the original position.
    2. Secure the cable retaining tabs to the frame.
    3. Install the intermediate cable end to the equalizer.
    4. Install the nut to the threaded end of the intermediate cable and tighten to 4 N.m (31 lb in).
  5. Lower the vehicle.
  6. Install the master cylinder. Perform the following steps:
    1. Mount the master cylinder to the brake booster.
    2. Install the master cylinder mounting nuts and tighten to 36 N.m (27 lb ft).
scientia non olet · About LEMON Manuals