Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Locate the relay. Refer to the Master Electrical Component List to locate the relay in the vehicle.
- Remove any fasteners which hold the relay in place.
- Remove any connector position assurance (CPA) devices or secondary locks.
- Separate the relay (1) from the wire harness connector (2).
NOTE:
Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.