LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 320 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING:

    Refer to SIR Warning .

  1. Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
  2. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    3. Fig 1: Releasing Tabs On Ignition Switch
    GM1413831Courtesy of GENERAL MOTORS CORP.
  3. Insert release tool J-42759 into the ignition lock cylinder case to release the tabs on the ignition/start switch.
  4. Pull the ignition and start switch out of the ignition lock cylinder case.
  5. Disconnect the electrical connector from the ignition/start switch.
scientia non olet · About LEMON Manuals