Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ignition lock cylinder case (1) to the vehicle.
- Install the 3 ignition lock cylinder case screws (2).
Tighten
Tighten the screws to 7 N.m (62 lb in).
- Install the park lock cable into the lock cylinder housing.
- Connect the passlock and key buzzer to the ignition lock cylinder case.
- Install the ignition/start switch. Refer to Ignition and Start Switch Replacement .
- Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Airbag Coil Replacement .
CAUTION:
Refer to Fastener Caution .