LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 320 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> 175 Amp Mega Fuse Replacement (with TP2) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the fuse cover.
    3. Fig 2: Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  3. Remove the starter solenoid cable nut (1) from the fuse stud.
  4. Remove the starter solenoid cable terminal (2) from the fuse stud.
    5. Fig 3: Generator Battery Jumper Cable
    GM1699546Courtesy of GENERAL MOTORS CORP.
  5. Remove the generator battery jumper cable to fuse nut (3).
  6. Remove the generator battery jumper cable terminal (4) from the fuse stud.
  7. Remove the positive battery cable terminal from the fuse stud.
    8. Fig 4: Fuse And Holder
    GM1714852Courtesy of GENERAL MOTORS CORP.
  8. Remove the fuse from the holder.
scientia non olet · About LEMON Manuals