Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Remove the plastic caps from the quick connect fittings by pulling the caps back along the pipe before installation.

Fig 1: Special Tool On Transmission Oil Cooler Pipe

GM1195053

Courtesy of GENERAL MOTORS CORP.

Install the DT-47731 onto the engine oil cooler (EOC) pipe, or use the J 28585

Fig 2: Sliding Special Tool Toward Pipe Fitting

GM1195054

Courtesy of GENERAL MOTORS CORP.

Slide the DT-47731 toward the EOC pipe fitting, or use the J 28585

Fig 3: Rotating Quick-Connect On Coolant Pipe

GM1195056

Courtesy of GENERAL MOTORS CORP.

NOTE:

Rotate the DT-47731 to engage the EOC pipe fitting's retainer slots.

The DT-47731 should be nearly flush with the fitting.

Connect the DT-47731 onto the EOC pipe fitting.

Fig 4: Rotating Quick-Connect Until Retainer Clip Rises Above Fitting Retainer Seat

GM1195059

Courtesy of GENERAL MOTORS CORP.

Rotate the DT-47731 or use the J 28585 until the retainer clip (1) rises above the fitting retainer seat.

Fig 5: Disengaging Pipe From Pipe Fitting

GM1195062

Courtesy of GENERAL MOTORS CORP.

Pull back on the EOC pipe to disengage the pipe from the EOC pipe fitting.
Remove the DT-47731 or the J 28585 from the EOC pipe.