Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Generator Cooling Inlet Pipe & Generator Cooling Inlet Pipe Fitting

Courtesy of GENERAL MOTORS CORP.

NOTE:

Discard the EOC retaining clip and install a new retaining clip.

Install the EOC pipe into the EOC pipe fitting.
A distinct snap should be heard or felt when assembling the EOC pipe to the fitting.
To ensure the cooler line is properly installed, give the cooler pipe a gentle pull.