LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 319 (Engine Cooling System) >> Repair Instructions >> Engine Coolant Air Bleed Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Coolant Air Bleed Hose And Pipe
    GM790766Courtesy of GENERAL MOTORS CORP.
  1. Install the coolant air bleed hose (1) to the pipe (2).
  2. Position the hose clamp at the pipe.
    3. Fig 2: Coolant Air Bleed Hose
    GM846664Courtesy of GENERAL MOTORS CORP.
  3. Install the coolant air bleed hose to the throttle body.
  4. Position the coolant air bleed hose clamp at the throttle body.
  5. If necessary, install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement for the 4.8L, 5.3L, and 6.0L engines.
  6. Add engine coolant, if necessary.
scientia non olet · About LEMON Manuals