LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 319 (Engine Cooling System) >> Repair Instructions >> Coolant Heater Cord Replacement (With LY2, LY5 or LMG) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Pan Skid Plate And Bolts
    GM1698082Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the oil pan skid plate bolts and plate, if equipped.
    3. Fig 2: Coolant Heater Cord
    GM1699548Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the coolant heater cord electrical connector.
    4. Fig 3: Coolant Heater Cord And Components
    GM1702203Courtesy of GENERAL MOTORS CORP.
  4. Remove the coolant heater cord retainer (5) from the frame.
  5. Remove the coolant heater cord clip (6) from the front brake front pipe.
  6. Lower the vehicle.
  7. Remove the coolant heater cord bolt (4) from the frame.
  8. Remove the coolant heater cord clip (2) from the chassis harness.
  9. Remove the coolant heater cord clip (1) from the front spring stud.
  10. Remove the coolant heater cord from the vehicle.
scientia non olet · About LEMON Manuals