LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 319 (Engine Cooling System) >> Diagnostic Information and Procedures >> Cooling Fan Always On (with HP2) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
    3. NOTE:

    The following tests must be performed on each cooling fan relay.

  3. Ignition OFF, disconnect each cooling fan relay one at a time.
  4. Ignition ON, observe that the fans are not activated.
    • If the fans are activated, test for a short to voltage in the relay controlled output circuit.
    • If the fans are not activated, test or replace the appropriate cooling fan relay.
scientia non olet · About LEMON Manuals