Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the striker.
- Install the spacer, if equipped.
- Install the upper striker bolt (1).
- If the striker backing plate has moved, rotate the lower striker bolt until the upper threaded hole is properly aligned.
- Remove the lower bolt.
- Rotate the striker (2) and the spacer, if equipped, in order to align the lower threaded hole in the striker backing plate.
- Tighten the striker bolts to 24 N.m (18 lb ft).
CAUTION:
Refer to Fastener Caution .